Just got a few fixtures I had to build a profile for, and the intensity and strobe were on the same channel. So when I start a chase they strobe as the chase starts up....how do i get them to start up after the strobe range on the channel...thanks!
I'm not sure but you might be able to deactivate this unwanted fade effect by tweaking your library:
Hope this helps
Really depends on your Intensity/Strobe channel setup...
It oddly seems the Strobe range starts at 0, while Intensity range ends at 255??
If so, set the default value for this attribute, to Intensity 0% value (e.g. 127)Set Fade mode, to FADE