I managed to do this once before, however when I try to replicate it the programmer loads both the pan and tilt, not just the pan only, and I can't for the life of me figure out how to get rid of the tilt value.
There's no option I can find to clear the tilt FX MODE ONLY from the programmer, or how to get just the PAN FX MODE only to load in the first place. They seem to both load even though the top of the fixture parameters window shows "22 fixtures selected / Mode on Pan", but if I click one of the mode choices, BOTH pan and tilt modes load into the programmer.
When this happens=, it loads the programmer with Mode 24 (pan inverted) into BOTH the FX pan and FX TILT slots for all selected fixtures, and if I DID want to load a tilt invert on half of them (which I most certainly DON'T in this case) that would be mode 44 for the tilt FX mode attribute.
Is this a bug, or am I just missing something obvious. As I mentioned I got this to work right once before but can't get it to work again.